Trimming Quadcopter Videos

Quadcopter stabilisation issues / trim issues

Since I've installed my gear on a SK450 frame from HobbyKing, I cannot get a stable configuration. All hardware and firmware are the same as on my on build f...

JBs H-Quad Trimming Quadcopter before FPV flight - Wilsons Promontory

FaceBook Page http://facebook.com/BmswebYoutube JB Testing and trimming his H-Quad out before his FPV flight over Squeaky Beach at Wilsons Promontory in ...

Disastrous Trim Experiments on my X525 Quad Copter

I'm adjusting the trims on my Flysky tx to get my X525 quad copter to fly better. I'm using a KK board, version 5.5, with the 4.7 firmware installed.

Quadcopter X525 trimming EXPO D/R setting up

Quadcopter X525 trimming EXPO D/R setting up. Setting up the Flysky 9x for the quadcopter, still some tweaking to do witht he servo throw, expo, d/r etc but ...

WLtoys V929 Beetle 4-Axis Quadcopter - Trim issue resolved

Example of the funny behavior that occurs when you plug the copter in - it sways to one side each time dramatically, and trimming the controller wont help. I...

Disastrous Trim Experiments on my X525 Quad Copter Part 2

This is what happens when you're conducting trim experiments on your quad copter, and it's got a busted / repaired motor mount on it!

Quadcopter first test flight (8.11.2011)

For setup see: http://humdi.net/wiki/rc/3s-quadcopter MultiWiiCopter 1.8p2 in acro mode with default PID settings. Some counterclockwise yaw trim was require...

Quadcopter Tuning and Practice

Quadcopter Tuning and Practice.

Tree Trimming - Fuji W3 3D FPV GU-INS Quadcopter flight

More practicing at the local park. Broke a prop and a leg in the process. Also I have been trying to refine the stereo alignment of the movies. The W3 is goo...

Quadcopter X525 trimming with crashes rear camera

Quadcopter X525 trimming with crashes rear camera.

QUADCOPTER TRIMMING WILLOW TREE

New use for quadcopter, trimming out of reach willow branches - all going well until the end.

X525 Quadcopter not trimmed with poor direction markings 1

X525 Quadcopter not trimmed with poor direction markings. Turns out the LEDs I put at the front and rear of the quad do not give a good enough direction indi...

Quadcopter X525 trimming with crashes

Quadcopter X525 trimming with crashes.

Quadcopter / H-Quad Update

Rebuilt, painted, and ready for action.

Quadcopter - Learning how to trim the PI-loop and fly :-)

I'm slowly learning how to trim the FC and fly. This quad has a lot of power, I really need to scale down the throttle response. I'm using the following setu...

World's Smallest Quadcopter FPV Setup - Walkera Ladybird FPV

Get it here - http://xheli.com/walkeraheli-ladybird-v2-fpv-f4-rtf.html Xheli has just received shipment of the Walkera Ladybird V2 First Person View quad...

Quadcopter with KK Board. How to reverse, hover test and adjust gyro.

This is an updated version of my previous video about reversing gyro's. Thought I would share what I learned. Using KK board on XAircraft 450 Frame, Turnigy ...

Bright orange tree blossems and unexpected quadcopter pruning fail. Cost 2 props FPV

Practicing close proximity flying with the 1155g hoverbot. More cam bracing required but overall good control until I pitched in a bit too fast. . Well I did...

Hubsan X4 recalibration.(MODE 2)

This video shows you hou to calibrate the hubsan X4 (MODE 2). You must calibrate the hubsan x4 before your maiden flight becouse if you don´t the hubsan x4 b...

Turnigy 9x (ER9x) Programmed for Quadcopter

Decided to bite the bullet and program my Turnigy 9x (ER9x) for my quadcopters. Now I use only one "model" setting for all my quads and can activate all four...

Turnigy HAL quadcopter build part 3 : building the upper deck

Love spending time in my workshop, so what better to do on a rainy day than to work on some projects. Designing, cutting, sanding, trimming and mounting the ...

H - QuadCopter Overview - GoPro Hero3 Black Edition Footage

Please Like us on our FaceBook Page - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - http://facebook.com/BmswebYoutube JB gives us and ove...

Key West Quadcopter Iguana video

An iguana in the tree, 13Mph+ winds. Playing with the HK/DJI quadcopter. HK 450 2.0 frame with green and black arms (extra purchase) DJI 2212/920kv motors DJ...

HobbyKing Quadcopter KK board setup guide

Here is a video I made to help people with setting up a new KK multicopter board. i hope it helps and please thumbs up if it did! programing video to come so...

Tree Trimming - FPV Aerial Views - Sequoia Park Zoo

Check out the XP2 Quadcopter used to make this video: http://xproheli.com#oid=5_1 Just a compilation of shots taken of Erik Tjossem from Cutting Edge Tre...

Syma X1 Unbox, Review and Test Flight and Flips

Update: Just wanted to see if this would bind to the Turnigy 9X, it does, flew it with stock settings for 30-40 seconds a bit sluggish but something to mess ...

X525 Quadcopter not trimmed with poor direction markings 2

Same again X525 Quadcopter not trimmed with poor direction markings. Turns out the LEDs I put at the front and rear of the quad do not give a good enough dir...

Syma RC X1 Quadcopter 2.4Ghz 4 Channel FUN FLY

Syma RC introduces its newest X1 Quadcopter! A quadcopter is a machine that is lifted and propelled by four rotors. Unlike most helicopters, a quadcopter use...

BlackHawk Quadcopter Revealed

http://onlyflyingmachines.com It is finally the time to reveal our new BlackHawk Quadcopter offering total new and futuristic look. This quadcopter is ba...

HOBBYKING KK2.0 QUADCOPTER (1 OF 6)

Flight test of my mates, hobbyking quadcopter, looks the part, a bit more trimming, and this will be one awesome quadcopter.

How To Trim Your RC Quad For Beginners

My cousin in Greece has just built his Hexa and flown it in the back yard. Strangely he does not know how to trim his multicopter ?

kk Quadcopter first test (testing connections) .AVI

Mine kkcopter is coming alive! First test, , EVER!, looks good, will check another day if al the motors react as it shoud. and test, gyro movement,and intera...

More flying quadcopter for Dad and Kamsi

HobbyKing Quadcopter Control Board - review and basic setup

First look and basic setup of the HobbyKing Quadcopter Control Board. http://hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=17537&aff=13680.

WL Toys V959 Quad Copter First Video

WL Toys v959 Quad Copter First Video Test.

HOBBYKING KK2.0 QUADCOPTER (3 OF 6)

Flight test of my mates, hobbyking quadcopter, looks the part, a bit more trimming, and this will be one awesome quadcopter.

How to program v929 quad copter part 2 advanced. Dual rates with stunt and normal mode.

Flight demonstration at the end. This is part 2 of 2, of my video programming the wl v929 with turnigy 9x v2. I go over dual rates for stunt / flip mode, exp...

Home-made fold-able wood quadcopter H-frame

This is my first attempt of making my own wood-based quad-copter H frames The design is very simple and I'm happy with the result, it cost me round 5$ of mat...

X525 Quadcopter Crash

I go a little bolder with my X525 quadcopter and bottom line was once I got up higher into the strong winds things got out of control. I had two unplanned la...

Quadcopter FPV test slow motion

Recorded with a Sony HDR-AS10, 720p 60fps.

Turnigy 9x Transmitter & 3 Mode Auxiliary Switch for Different Flight Modes with APM 2.5 Quadcopter

I purchased my Turnigy 9X from eBay so be sure to check there: http://fave.co/UpCACF I've received several requests about configuring the Turnigy 9X 3-way au...

5000 Subscribers & Flite Test Competition & Bad Weather

http://facebook.com/BmswebYoutube Firstly a Big THANK YOU to all our subscribers and many of you who have become Friends too :) This video is very differ...

WLTOYS V929 mini quadcopter unbox & set up

WLTOYS V929 mini quadcopter unbox set up bought from ebay.

Quadcopter Q450 pe vant puternic

Vant de aproximativ 25 km/h.

My Quadcopter and my crash

This is my basic run of the mill DJI clone using the following. HobbyKing Q450 frame NTM 2826 1000kv motors HobbyKing Blue Series 20 amp ESC's KK2 Flight Con...

Crazyflie Nano Quadcopter pre-release video

Now available at http://seeedstudio.com/depot/bitcraze-m-64.html Showing off some features, flight characteristics and hacks of the Crazyflie Nano Quadco...

Blade MQX Quad Copter Maiden

Well I had to get one... The Blade Quad MQX and it is a BLAST and so stable it is sick! This is the maiden flight out front of the house and it is straight o...

Heliguy Viper - Adjusting the Sensitivity of the Transmitter

This is a new Viper with a new transmitter. I noticed that the new transmitter was fine except for the rudder control - it was very sensitive and made the mo...